40D verres de visée en MAP manuelle

[chirouille]

Sur mon 40D ils sont toujours visibles, sur le 30D cela doit être la même chose.

[Frodo]

Si ça peut aider certains utilisateurs de verres de visée type K3, on peut trouver sur le site katz...quelquechose un tas d'infos concernant les corrections d'exposition à apporter en fonction des boîtiers et ouvertures utilisées.

Je suis peut-être neuneu mais je n'ai rien trouvé sur leur site, sauf une phrase vague disant que ça peut affecter la mesure. Si quelqu'un plus doué que moi peut fournir le lien, merci d'avance.

[chirouille]

Pour 40D:

• Evaluative Metering Mode: Our testing showed evaluative mode to be within factory tolerance for all lenses having a maximum aperture of f4.5 or larger (lower f number). AF lenses with a maximum aperture of f5.6 or slower (higher f number) will overexpose slightly. With an f5.6 AF lens, we recommend an exposure compensation of -2/3EV. Manual (non-CPU) lenses with a maximum aperture of f5.6 or slower (higher f number) will underexpose slightly. With an f5.6 non-CPU lens, we recommend an exposure compensation of +2/3EV.
• Center Weighted Average (CWA) Metering Mode: Our testing showed CWA metering mode to be within factory tolerance for all lenses having a maximum aperture of f4.5 or larger (lower f number). Lenses with a maximum aperture of f5.6 or slower (higher f number) will underexpose very slightly. With an f5.6 lens, we recommend an exposure compensation of +1/3EV.
• Partial Metering Mode: Our testing showed partial metering mode to be within factory tolerance for all lenses having a maximum aperture of f2.0 or larger (lower f number). Lenses having a maximum aperture smaller than f2.0 (lager f number) will show a shift toward increased exposure. The shift will be greater for lenses with smaller maximum apertures. When using partial metering mode, it is advisable to first take a test shot, check the histogram, and adjust exposure compensation as required. Starting points for exposure compensation are as follows: f2.8 lens: -1/3EV, f4.0 lens: -2/3EV, f5.6 lens: -1EV.
• Spot Metering Mode: Our testing showed spot metering mode to be within factory tolerance for all lenses having a maximum aperture of f2.0 or larger (lower f number). Lenses having a maximum aperture smaller than f2.0 (lager f number) will show a significant shift toward increased exposure, with the shift increasing for lenses with smaller maximum apertures. Spot metering mode is not recommended when using a split prism focusing screen except with very fast prime lenses. However, if spot mode must be used, it is strongly advised to first take a test shot, check the histogram, and adjust exposure compensation as required.